I have just set up my Zonelab 100 G and have the Wiereless Network communicating with wired resources. I am having a problem getting the DLink DP-G321 print server to even get a link from the router. Any suggestions.

I could advise the following...

1.-Make a rule to let the WLAN see the LAN.. search the forums for this if you like...
2.-For the wireless print server start testing it with NO encription/authentication, if it works then go with WEP, if it works then go with WPA, and so on...

Good luck

One troubleshooting tip is to force the printserver to dump a configuration/status page to the printer -- if it is using dhcp, what the address is that it may have gotten from the router, etc. I think this printserver has a pinhole button on the rear -- if you push it quickly it should generate a printout.

Another option is to press the pinhole reset in the back for 5 seconds to reset the printserver to factory defaults. Then go from there.

One other comment -- that is an end-of-life product. Could it be doing something odd -- like need you to run an application to configure it ?

Hope that helps,
Jeff N.