I have a safe@office 500 v. 7.5.48x. I have 2 different ISP hooked up the WAN and DMZ/WAN2 port. I have set the DMZ as a WAN port. The odd thing is once I enable the WAN2 port all traffic is now passed/forward out to the WAN2 port. I have checked the routing table in the GUI interface and it shows the WAN1 port with a lower metric then the WAN2 port. 100 for WAN1 and 200 for WAN2. It is also forwarding NATed traffic from the WAN1 port out the WAN2 port. I have no additional routes or networks setup. The only thing I can think of is that the WAN2 port speed is 100M FDX and the WAN1 port is 10M HDX. I have tried setting the speed on the WAN2 port to 10M HDX but would only let me go to 10M FDX but even at this setting it still goes out the WAN2 port.
Any suggestions as to why it is doing this?

I appologize it apears that only NATed traffic is leaving the WAN2 port and all non NATed traffic leaves out the WAN1 port as it should.